商品詳細
ELS000001-00920148 商品名：Cisco スイッチ【WS-C2960X-24TD-L】 ★初期化済み★ ◆商品状態 初期化作業を行いました。 ※こちらの商品は詳細な動作確認を行っておりませんので、ノークレーム・ノーリターン・ノーサポートでお願いします。 ◆商品外観 品の為、キズ等があります。 ◆付属品 ・電源ケーブル ◆コンソール出力 cisco WS-C2960X-24TD-L (APM86XXX) processor (revision H0) with 524288K bytes of memory.Processor board ID FCWLast reset from power-on1 Virtual Ethernet interface1 FastEthernet interface26 Gigabit Ethernet interfaces2 Ten Gigabit Ethernet interfacesThe password-recovery mechanism is enabled.512K bytes of flash-simulated non-volatile configuration memory.Base ethernet MAC Address : BC:C4:93:48:72:00Motherboard assembly number : 73-15968-02Power supply part number : 341-0529-02Motherboard serial number : FOCPower supply serial number : LIT19100FWZModel revision number : H0Motherboard revision number : B0Model number : WS-C2960X-24TD-LDaughterboard assembly number : 73-14200-03Daughterboard serial number : FOCSystem serial number : FCWTop Assembly Part Number : 800-41465-01Top Assembly Revision Number : C0Version ID : V03CLEI Code Number : CMML610ARBDaughterboard revision number : A0Hardware Board Revision Number : 0x12Switch Ports Model SW Version SW Image ------ ----- ----- ---------- ---------- * 2 28 WS-C2960X-24TD-L 15.0(2a)EX5 C2960X-UNIVERSALK9-M Press RETURN to get started!*Mar 1 00:00:24.019: Read env variable - LICENSE_BOOT_LEVEL = Mar 30 01:27:38.150: %IOS_LICENSE_IMAGE_APPLICATION-6-LICENSE_LEVEL: Module name = c2960x_lanbase Next reboot level = lanbase and License = lanbaseMay 27 05:27:44.933: Flexstack module is 1 May 27 05:28:43.220: %STACKMGR-4-SWITCH_ADDED: Switch 2 has been ADDED to the stackMay 27 05:28:44.390: %LINEPROTO-5-UPDOWN: Line protocol on Interface Vlan1, changed state to downMay 27 05:28:44.939: %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0, changed state to downMay 27 05:28:46.666: %SPANTREE-5-EXTENDED_SYSID: Extended SysId enabled for type vlanMay 27 05:29:08.669: %STACKMGR-5-SWITCH_READY: Switch 2 is READYMay 27 05:29:08.669: %STACKMGR-4-STACK_LINK_CHANGE: Stack Port 1 Switch 2 has changed to state DOWNMay 27 05:29:08.669: %STACKMGR-4-STACK_LINK_CHANGE: Stack Port 2 Switch 2 has changed to state DOWNMay 27 05:29:08.969: %STACKMGR-5-MASTER_READY: Master Switch 2 is READYMay 27 05:29:08.973: %SYS-5-RESTART: System restarted --Cisco IOS Software, C2960X Software (C2960X-UNIVERSALK9-M), Version 15.0(2a)EX5, RELEASE SOFTWARE (fc3)Technical Support: http://www.cisco.com/techsupportCopyright (c) 1986-2015 by Cisco Systems, Inc.Compiled Mon 16-Feb-15 08:16 by prod_rel_teamMay 27 05:29:09.158: %PLATFORM-6-FLEXSTACK_INSERTED: FlexStack module inserted in Switch 2.May 27 05:29:10.965: %LINK-3-UPDOWN: Interface FastEthernet0, changed state to downMay 27 05:29:11.175: %USB_CONSOLE-6-MEDIA_RJ45: Console media-type is RJ45. --- System Configuration Dialog ---Enable secret warning----------------------------------In order to access the device manager, an enable secret is requiredIf you enter the initial configuration dialog, you will be prompted for the enable secretIf you choose not to enter the intial configuration dialog, or if you exit setup without setting the enable secret,please set an enable secret using the following CLI in configuration mode-enable secret 0 ----------------------------------Would you like to enter the initial configuration dialog? [yes/no]: nSwitch>enSwitch#sh May 27 05:29:27.029: %LINK-5-CHANGED: Interface Vlan1, changed state to administratively downMay 27 05:29:27.029: %LINK-5-CHANGED: Interface FastEthernet0, changed state to administratively downsSwitch#sh startup-configstartup-config is not presentSwitch#◆